Reverse Osmosis 150 200 GPD Booster Pump + Shut Off Switch + Solenoid + Gauge

  
Reverse Osmosis 150 to 200 GPD Diaphragm Booster Pump. DC 24 V Transformer + 2 Pcs Connect Fittings (1/4 inch tube x 3/8 inch Threaded)+ High Pressure Shut Off Switch + 1/4 inch Tube OD quick fit Solenoid Valve. For those who they have low incoming city water pressure less than 50 PSI or well water tank pressure 40 - 60 PSI. This pump will not increase the production volume or the pressure for those who they are on city water pressure 55 PSI and up. Reverse osmosis systems will increase your system input pressure then will increase the water production & purity as well if your city water pressure is lower than 50 PSI. This pressure gauge should be installed in between the third and forth stage before or after the auto shut off valve in your reverse osmosis system. You have to measure the PSI in your system when the pre-filters are new (usually it should be reading between 55 to 65 PSI). Any pressure drops (normally that will start after couple of months when the filters start clogging with dirt) then the pressure gauge will start reading between 45 to 50 PSI therefore this is a visible indication for you to change the filters. High pressure switch for reverse osmosis booster pump (on - off) operation control. High pressure switch job is to turn off the booster pump when the tank is full. The pump will automatically control all residential reverse osmosis systems. The pump turns on to produce water into the pressure tank, and then turns off when the pressure tank is full. This pump are able to work at least 3 months continuously without stop. This booster pump is designed for membranes rated 150 to and 200 GPD. It can be mounted in several positions.

Safe power operation with, low energy (low voltage - 24 volt). The motor of these boosters is Duty cycle will vary with load and ambient temperature; smoother running; longer life; and work with high efficiencies. Never Mind if its installed in warm, humid, hostile environment where other pumps can't operate in such hard environments. Product total weight with transformer 6 Lbs - Booster dimensions 6.5 inch X 4 inch X 4 inch. All required fittings & instruction manuals are included to DIY your own installation.

Flow Rate: 2.3 LPM. Working pressure: +/- 81 PSI. This pump is to be used with reverse osmosis systems 150 to 200GPD only. Output Volts :24 Volt DC. This item is in the category "Home & Garden\Kitchen, Dining & Bar\Small Kitchen Appliances\Water Purification\Water Filters".

usa" and is located in this country: US. This item can be shipped worldwide.

• Model: 105017-105108-105568-105597
• Power: 120 volt
• Type: Diaphragm Booster Pump
• Color: Multicolor
• MPN: 105017-105108-105568-105597
• Brand: Max Water
• Compatible Model: Max Water
• UPC: 700256130086