SimPure T1-400 UV Reverse Osmosis Water Filter Cartridges PP+CTO+RO 1-3-Year Set

  
PP Melt Blown Sediment Filter. PP Filter removes contaminants 1 micron or greater in diameter. Removes large particles, sediment, dirt, sand, rust, silt, iron, moss, pollen, protozoa and other organisms. CTO Activated Carbon Block Filter. CTO Filter removes contaminants 0.1 microns or greater in diameter.

It filters out large particulate matter and algae; adsorb chemicals such as carbon tetrachloride, chlorine and chloramines, lead, etc; Removes taste, odors and similar contaminants from water. RO Reverse Osmosis Membrane Filter. RO Filter removes contaminants 0.0001 microns or greater in diameter, Removes almost all of the metal ions, Impurities, heavy metals, colors, and dissolved solids by only allowing water molecules to pass through it.

It removes any remain tastes and odors, further improve the smooth taste of the drinking water. The sealed under sink water filter is made of durable materials, which will not break or leak. The integral design eliminates harmful impurity from breeding, which also allows you to get rid of replacing bottom cap. Replacement can be completed within 3 seconds with a single twist and no need to use any tool.

Providing you with the eaisest way to install without disassembly. Tap water passes through the PP Filter and CTO Filter and becomes primary purified water, the built-in booster pump will pressurize the primary purified water to 60-110PSI, the actual pressure value can be checked by the water pressure gauge display value. After the RO Filter T33 Filter, ALK Filter, and UV sterilization filtration, the water will become pure water for drinking, and the wastewater will flow out through the other end. When to change the filter. When the tap water temperature and pressure are normal (generally 40-104?

When the flow of pure water is less than 0.5L/min, the filter cartridges need to be replaced (It is normal for the flow rate in summer to be slightly higher than the flow rate in winter). Check the value of the water pressure gauge. Through the RO filter before the pressure detection (generally normal in the 60-110PSI or so), if more than 130psi, and the wastewater valve is not blocked, then you need to replace the RO Filter, followed by the T33 Filter. If the tap water pressure is 40psi, but the water pressure gauge shows much lower than 40psi, you need to replace the PP Filter, followed by the CTO Filter. The actual service life of the filter element depends on the amount of water consumption and quality.

Please refer to the pressure gauge data for the actual replacement time. Not all of the filters are included in the package, please choose the "ITEM TYPE" you need in the selection.